C3.3 Generator Set
Caterpillar is leading the power generation marketplace with Power Solutions engineered to deliver unmatched flexibility, expandability, reliability, and cost-effectiveness.
Generator Set Specifications
Maximum Rating
Minimum Rating
Emissions/Fuel Strategy
Voltage
Frequency
Speed
Duty Cycle
Engine Specifications
Engine Model
Bore
Stroke
Displacement
Compression Ratio
Aspiration
Fuel System
Governor Type
Generator Set Dimensions
Length - Maximum
Width - Maximum
Height - Maximum
Standard Equipment:
-
- Air Inlet System
-
- Air cleaner; light duty with disposable element
-
- Control Panel
-
- GCCP 1.3
-
- Cooling System
-
- Coolant drain line with valve
- Caterpillar extended life coolant
- Radiator and cooling fan with guards
- Fan drive, battery charging alternator drive
-
- Exhaust System
-
- Stub pipe, gaskets, raincap & SAE exhaust flange for customer use - shipped loose
-
- Fuel System
-
- Standard open set fuel tank/base supplied
- Base, formed steel with single wall integral 8-hour fuel tank
-
- Generators And Generator Attachments
-
- Circuit breaker, IEC, 3 pole, mounted in tower panel
- IP23 Protection
- Tower panel, IP22, bottom cable entry
- 12 Leads
- Voltage regulator (single phase sensing)
- Segregated low voltage (AC/DC) wiring panel
-
- Governing System
-
- Mechanical governing system - model dependant
- Mechanical and electrical governing system - model dependant
-
- Lube System
-
- Lubricating oil
- Oil drain line with valve
-
- Mounting System
-
- includes lifting provisions and termination points for coolant
- Includes lifting provision and drag points
- Termination points for coolant and lube oil drain lines
- Captive linear vibration isolators between base and engine-generator
-
- Starting / Charging System
-
- 12V Battery with rack & cables
-
- General
-
- Engine and alternator pre-paint, Caterpillar yellow
Optional Equipment:
-
- Alternator System
-
- LC Frame alternator
- Anti-condensation heater
- Permanent magnet excitation (PMG)
- LC Frame alternator with coastal protection
- R Frame auxilliary winding
-
- Alternator
-
- Alternator removal options
-
- Circuit Breakers
-
- 4 Pole Circuit breaker to 250A
- Padlockable breaker device
-
- Control Panels
-
- GCCP 1.3
-
- Control Panel Options
-
- Overload shutdown via breaker
- Volt free contacts
- Earth leakage (2 wire only)
- Speed adjust potentiometer
- Voltage adjust potentiometer
- Battery charger
- Control panel heater
- Earth fault (2 wire only)
- Panel mounted audible alarm
- Emergency stop with key
-
- Cooling System
-
- Coolant heater
- Low coolant level shutdown
- Low coolant temperature alarm
-
- Certifications
-
- European upgrade to STD set for "CE"
- Global certification for CIS
-
- Enclosures
-
- CEE for sockets for enclosure
- Socket blanking plate
- Sound attenuated level 1 enclosure (GALV)
- Sound attenuated level 2 enclosure CE
- Rental pack (CAE only)
-
- Fuel System
-
- Skidbase for CALG enclosure sets
- Low fuel level shutdown
- High fuel level alarm
- Compact skidbase for open sets
- Low fuel level alarm
- Bunded fuel tank
- Open set narrow tankbase
-
- Mounting Options
-
- Silencer installation kit
- Battery removal
- Electronic governor
- Residential silencer
- External single point lift - enclosure
-
- Special Packing Inspections
-
- PGS Test report @ 0.8 power factor
- PGS Test report @ 1.0 power factor
-
- General
-
- Stone guards/rad trans flange
- Packing case - compact set
- Packing case - canopied set
Contact Us
Get A Quote
Thank you for your interest in Mustang Cat. We are here to help you in any way that we can. If you have a question, need equipment advice or just need additional information, we want to hear from you. You can email, phone or fill out the form below and we will be happy to connect with you.