Black banner

Cat® 3412C Fire Pump

Cat® 3412C Fire Pump

Cat® 3412C Industrial Diesel Fire Pump Engines, with ratings: 476-551 kW (638-739 hp) @ 1750-2100 rpm, are non-certified and are available for global non-regulated areas. They are not FM Approved and not UL Listed. Starting on demand is a must for a fire pump engine – always. Cat® fire pump engines have a reputation for reliable starts and long efficient service. The Cat line of fire engine pumps covers a wide range of installations.

Power Rating

Maximum Power

739HP

Rated Speed

1750-2100 rpm

Minimum Power

638HP

Emission Standards

Emissions

Non-Certified. Available for global non-regulated areas. Not FM Approved, Not UL Listed

General

Engine Configuration

V-12, 4-Stroke-Cycle Diesel

Bore

5.4in

Stroke

6in

Displacement

1648in³

Compression Ratio

14.5:1

Aspiration

Turbocharged Aftercooled (TA)

Rotation from Flywheel End

Counterclockwise

Aftertreatment

-

Engine Dimensions - Approximate

Length

78.7in

Height

55.6in

Weight - Net Dry - Basic Operating Engine Without Optional Attachments

5686lb

Standard Equipment:

  • Air Inlet System
    • Air cleaner, regular duty with service indicators
    • Turbocharged
  • Cooling System
    • Thermostats and housing
    • Jacket water pump, centrifugal
    • Heat exchanger installed
    • Expansion tank
  • Control System
    • Charging alternator 24 volt, 35 amp
    • Governor control
    • Hydra-mechanical governor
  • Exhaust System
    • Exhaust manifold
    • Exhaust elbow, dry. 203 mm (8 in) on all Turbocharged engines and Turbocharged Aftercooled with wet exhaust. 152 mm (6 in) on Turbocharged Aftercooled with dry manifolds.
  • Flywheels & Flywheel Housings
    • SAE No. 0 flywheel
    • SAE No. 0 flywheel housing
    • SAE standard rotation
  • Fuel System
    • Fuel filter
    • Fuel transfer pump
    • Primary fuel filter
    • Fuel priming pump
  • Instrumentation
    • Instrument panel, LH
    • Engine oil pressure gauge
    • Fuel pressure gauge
    • Water temperature gauge
    • Tachometer
  • Lube System
    • Crankcase breather, top mounted
    • Oil cooler
    • Oil filler in valve cover and dipstick, both RH
    • Lube oil filter
    • Rear sump oil pan
  • Mounting System
    • Supports
  • Power Take Off
    • Power take-off (PTO) flywheel stub shaft
  • Protection System
    • Stop-Start System, automatic (compatible with NFPA 20 requirements, able to be energized from either of two battery sources and capable of manual starter actuation)
  • Starting System
    • 24 volt, LH electric starting motor
    • Jacket water heater (6 kW, 240-480 volt)
  • General
    • Paint: Firepump Red
    • Vibration damper and guard
    • Lifting eyes

Optional Equipment:

Contact Us

Get A Quote

Thank you for your interest in Mustang Cat. We are here to help you in any way that we can. If you have a question, need equipment advice or just need additional information, we want to hear from you. You can email, phone or fill out the form below and we will be happy to connect with you.

    true I agree to all the terms and conditions

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.