3512C (HD) Offshore Well Stimulation Engine
The 3512C (HD) offshore engine for well stimulation operations was specifically developed to operate in harsh environments offshore while meeting the highest standards in performance, durability, reliability, and emissions. Cat engines are backed by the worldwide network of Cat dealers ready to support your operation with technical support, service, parts, and warranty. 3512C (HD) offshore engines, with ratings: 1678-1864 bkW (2250-2500 bhp) @ 1900 rpm meet IMO Tier II and U.S. EPA Marine Tier 2 emission standards.
General Specifications
Maximum Rating
Displacement
Minimum Rating
Aspiration
Flywheel and Flywheel Housing
Flywheel Teeth
Stroke
Bore
Emissions
Emissions
Dimensions
Length
Width
Height
Weight
Standard Equipment:
-
- Air Inlet System
-
- Heavy-duty air cleaners (dual element/service indicator)
- Four center-mounted turbochargers
-
- Control System
-
- Cat® ADEM A3 ECU — LH
- With electronic fuel injector fuel system (10 amp DC power required to drive electronic engine control module)
-
- Cooling System
-
- Separate Circuit SCAC system
- Torque converter connections
- Thermostats and housing, jacket and separate circuit water pump, gear-driven centrifugal
-
- Exhaust System
-
- Land well service engine
- Exhaust manifold, dry, slip joint with stainless steel wire seal
- Four turbochargers with watercooled bearings (center mounted)
- Exhaust outlet, dual 203 mm (8 in) round flange
-
- Flywheel And Flywheel Housings
-
- Flywheel, SAE No. 0, 151 teeth
- Flywheel housing, SAE No. 0
-
- Fuel System
-
- Primary fuel filter
- Fuel priming pump
- Fuel filter — RH spin-on type
- Fuel transfer pump
- Electronically controlled unit injectors
-
- Instrumentation
-
- No standard instrumentation
- Optional, remote instrumentation available
- Service meter
-
- Lube System
-
- Crankcase breather — top mounted
- Oil cooler
- Oil filler and dipstick — LH
- Oil pump
- Oil filter — RH spin-on type
- Rear sump oil pan — 250-hour change interval
- Oil pan drain valve — 1" NPT female connection
- Fumes disposal
- Scavenger pump
-
- Mounting System
-
- Trunion front support
-
- Power Take-offs
-
- Accessory drive — lower LH
- Front housing — two-sided
-
- Protection System
-
- ADEM A3 ECU system to provide customer programmable engine deration strategies to protect against adverse operating conditions
- Emergency stop logic inputs provided at 40-pin customer interface connection
- Dual air inlet shutoff
- Oil pressure monitor
-
- General
-
- General
- Vibration damper and guard
- Lifting eyes
Optional Equipment:
-
- Charging System
-
- Charging alternators
-
- Control System
-
- Local speed throttle control
- Throttle position sensors
- Governor conversion
-
- Cooling System
-
- Coolant regulator conversion
- Water level switch gauge
- Coolant level sensors and coolant conditioner
-
- Exhaust System
-
- Flexible exhaust fitting
- Elbows, flange, exhaust adapters
- Manifold and mufflers
-
- Fuel Systems
-
- Flexible fuel lines
- Water/fuel separator
- Fuel level switch
-
- Instrumentation
-
- Remote panel display and remote cylinder temperature display
- Gauges and instrument panels
-
- Lube System
-
- Oil pans and filters
- Deep sump oil pan and front sump pan
-
- Power Take-offs
-
- Front crankshaft adapter
- Flywheel stub shaft
-
- Protection System
-
- Sensors
- Shutoff controls
-
- Starting System
-
- Air starting motors
- Electric starting motors
- Hydraulic starter
- Ether starting aids
- Battery sets — 24V
- Battery cable and battery rack
Contact Us
Get A Quote
Thank you for your interest in Mustang Cat. We are here to help you in any way that we can. If you have a question, need equipment advice or just need additional information, we want to hear from you. You can email, phone or fill out the form below and we will be happy to connect with you.